In mm/min those are 2250 mm/min and 1125 mm/min. Unfortunately most 3018's also have their motor stepping rates set very high (either 800 or 1600 steps/mm), and an 8 bit GRBL controller will only output about 30,000 steps per second, so you're limited to a max of 37.5mm/sec (if you have 800 steps/mm) or 18.75mm/sec (if you have 1600 steps/mm). This will likely be set to about 500, which means 500 mm/minute, or about 8.3 mm/sec, and this is really slow for a laser. Maximum speed for the X and Y axis are controlled by $110 and $111. This is required for LightBurn to correctly understand the machine. Status reporting is controlled by $10 - Set this to 0 which will tell the machine to report workspace position, not absolute machine position. Variable power requires that the M4 tool command is used instead of M3, so make sure you are using the GRBL and not GRBL-M3 device profile to take advantage of variable power. Using this mode means also allows for Variable Power mode which means the laser adjusts the power output from 0% at a dead stop to whatever power you request when it gets to the requested speed. Laser Mode means that you don't have a rotating spindle tool, and therefore we're not pausing to wait for it to speed up / slow down when the PWM output changes, and the PWM output needs to be turned off when moving between cuts. Set this to 1 (or true / enabled in Machine Settings). More information about configuring GRBL can be on the official GRBL documentaion site. The settings you'll most likely need to change are listed below. Both are showing the same values, but the Machine Settings view in LightBurn is a little easier to use. To see the existing settings, you can type $$ into the console in LightBurn and press enter, or go to Edit > Machine Settings. You're trying to move too fast, which is why you don't get enough powerģ018's are pre-configured for use as CNC machines, not lasers, so their settings and speeds will likely need to be changed to give you acceptable results with LightBurn.Turn on Laser Mode to get rid of the travel lines.

Lightburn cnc